What version of wall controller do I need to have for WiFi control?
- For WiFi control of your compatible heater (or cooler) ALL MagIQtouch controllers on the system need to be software version 44R0418 or greater.
- To confirm Software version. Select SETTINGS from bottom task bar and GENERAL from the top header. Page down to the SOFTWARE REVISION and read software version
What Seeley International models are WiFi compatible?
- Any Seeley International Q series product has the ability to have a MagIQtouch WiFi controller connected to it
- If adding WiFi to existing Q series models you need additional components
- If you have an existing non - WiFi compatible MagIQtouch or you do not have WiFi system already you will need to order Kit 118277 NOTE : Kit is for Master wall control only, additional WiFi compatible wall controllers will have to be purchased for each zone with an existing MagIQtouch
How do I check if my current system is Wi-Fi ready?
- You will need WiFi compatible controller(s) on the whole system. Software version 44R0418 or later. Software version can be found from your wall controller. Select SETTINGS from the bottom task bar and GENERAL from the top header. Page down to the SOFTWARE REVISION menu and read the software version
- You will need a WiFi module. This may be mounted in the ceiling with the heater and looks like the image below. You can also check by selecting SETTINGS from the bottom task bar and SERVICE from the top header. In the list after “the following parts were found on the system” you should see “WI-FI SMART CONTROLLER WIFI – SC”