⚠️Safety Notice – Wall Furnace Products
This appliance must only be installed, commissioned, serviced and repaired by suitably qualified and licensed personnel.
Before commencing work, complete a risk assessment and ensure gas and electrical safety, combustion air requirements, flue integrity, safe clearances and appropriate PPE have been considered. All work must comply with applicable regulations, standards and manufacturer requirements.
Particular care must be taken when working around gas systems, electrical components, combustion products, hot surfaces, flue systems and roof or ceiling spaces associated with the flue installation.
Do not proceed if safe access, flueing requirements, required clearances or appropriate safety controls cannot be maintained.
Safety takes priority over diagnosis, repairs and installation schedules. If the task cannot be completed safely, it must not proceed.
- When replacing an existing wall furnace with a WF25 you must purchase and install a new coaxial (balanced) flue system as any existing updraft flue will not be compatible.
- WF25 is not suitable for direct replacement of fully recessed models installed into double brick walls
- Where the existing wall furnace cut-out exceeds 1800mm high , infill panel kit (085135) can be used to cover the gap *** NB: Infill panel kit (085135) is suitable for inbuilt installations only ***
Regards
Seeley International
Technical Support
Phone:1300 650 399
Seeley Service Web Resource is for suitably qualified personnel only and contains a large library of Seeley International Service/Installation/Technical/Training and Spare parts information. Follow the link https://www.seeleyinternational.com/login/ to register
Spare Parts Identification follow the link https://spares.seeleyinternational.com/parts