EWPE Wi‑Fi Firmware Update for LE60 Zone Controller – Fix for Zone Name Mismatch and Zone Errors

Overview

Some systems using the EWPE Wi‑Fi app may experience an issue where zone names displayed in the app do not match the names configured in the LE60 zone controller.

When this mismatch occurs, the controller may generate zone error messages, even though the system is operating normally.

Updating the LE60 zone controller firmware to Version 1.27 resolves this issue.

This guide outlines the steps required to update the firmware through the EWPE Wi‑Fi app.

Symptoms

You may be affected by this issue if:

Zone names shown in the EWPE Wi‑Fi app do not match the names on the LE60 zone controller.
The controller displays zone errors for multiple zones after connecting to Wi‑Fi.
Errors only clear when Wi‑Fi is disabled or the app is disconnected.

Cause

Older firmware versions may not synchronise zone naming correctly between the LE60 Zone Controller and the EWPE Wi‑Fi app.
Firmware V1.27 fixes this alignment problem.

How to Update LE60 Zone Controller Firmware (EWPE Wi‑Fi App)

1. Open the EWPE Wi‑Fi App

Launch the EWPE app on your mobile device and ensure you are connected to the unit.

2. Open the Zone Controller Menu

Navigate to your Zone Controller in the app interface.

3. Access the Settings Menu

Tap the three dots (⋮) located in the top‑right corner.

4. Select “Firmware Update”

Choose Firmware Update from the menu.

5. Update to Firmware Version V1.27

If prompted, confirm the update to V1.27.

Do not close the app or power off the controller while the update is in progress.

Result After Update

After the firmware update:

Zone names in the EWPE Wi‑Fi app will match correctly with the LE60 Zone Controller.
Zone error messages caused by mismatched naming will be resolved.
Normal system control and reliability will be restored.