System Modification: Evaporative Cooler 01 Not Detected and or green flashing LED on control box is not coming on, while the red SAL LED is on.
If this message appears after the cooler has been installed for a while and the power supply was unstable or interrupted, the electronics may have latched up. To reset without replacing any components:
- Turn off the power to the appliance for at least 1 minute before turning it back on.
Green flashing LED on control box is not coming on, while the red SAL LED is on and MagIQcool controller isn't responding to commands.
This issue may occur on systems using a MagIQcool controller after the cooler has been installed for a while and the power supply was unstable or interrupted. The electronics may have latched up. To reset without replacing any components:
- Turn off the power to the appliance for at least 1 minute before turning it back on.