MagIQtouch Controller – Program Mode Setup for Ducted Gas Heaters - Braemar DGH

⚠️ Safety Notice – Gas Heating Products

This appliance must only be installed, commissioned, serviced and repaired by suitably qualified and licensed personnel.

Before commencing work, complete a task-specific risk assessment and ensure gas and electrical safety requirements, ventilation provisions, safe access, adequate service clearances and appropriate PPE have been considered. All work must comply with applicable regulations, standards and manufacturer requirements.

Particular care must be taken when working around gas systems, electrical components, combustion products, hot surfaces, moving parts, roof spaces, ceiling spaces and confined spaces.

Do not proceed if safe access, required clearances, ventilation requirements, confined space risks or appropriate safety controls cannot be achieved and maintained. 

Safety takes priority over diagnosis, repairs, installation schedules and customer expectations. If the task cannot be completed safely, it must not proceed until the risks have been adequately controlled.

Overview

Program mode allows you to automatically run your ducted gas heater based on a daily schedule.

• The system uses a 7-day program
• Each day is divided into 4 time periods
• The controller will follow the schedule only when Program Mode is active

Video Guide

Watch how to set up Program Mode

How Program Mode Works (Ducted Gas Heating)

Each day is divided into four fixed time periods:

⚠️ These labels are fixed. You can only change:

• Start time
• ON / OFF status
• Set temperature

How to Set Up Program Mode

Step 1 – Enter Program Mode

1. Press PROGRAM on the controller
2. Select EDIT to begin programming

Step 2 – Select the Day(s)

• Choose a single day or multiple days to edit
• You can apply the same schedule across multiple days

Step 3 – Set Each Time Period

For each of the four time periods:

1. Select the time period (Wake / Away / Home / Sleep)
2. Set the start time
3. Select:
   • ON (heater runs to set temperature), or
   • OFF (heater will not run)
4. Set the required temperature
5. Save changes

Repeat this process for all four time periods

Step 4 – Save Program

• Confirm all settings
• Exit back to the Program screen

The schedule is now stored in the controller

How to Run the Program

To ensure the heater follows the schedule:

1. Set controller to PROGRAM mode
2. Ensure the system is ON

✅ If Program Mode is not selected, the schedule will not operate

Temporary Changes (Override Function)

• You can temporarily change the temperature during a programmed period
• The controller will return to the programmed schedule at the next time period

✔ This does not permanently change the program

Key Limitations (Important for Customers)

• Program mode always uses 4 predefined time periods per day
• You cannot add extra time periods
• You cannot rename the time periods
• Settings apply only when PROGRAM mode is active

(All behaviour above is consistent with controller operation shown in the manual and video)

Common Issues

Program not running

• Controller is not in PROGRAM mode
• System is turned OFF

Heater turning off unexpectedly

• The current time period is set to OFF

Temperature not matching expectations

• Check the set temperature for the active time period
• Confirm the correct day is programmed

✅ Summary

• 7-day programmable schedule
• 4 fixed time periods per day: Wake, Away, Home, Sleep
• Each period controls: time, ON/OFF, temperature
• Program only runs when PROGRAM mode is selected