RPA, RPB, RPC 3-Phase (Δ) and Single-Phase (Φ) 2-Speed Commercial Wiring - Current and Historical Diagrams
⚠️ Safety Notice – Commercial Evaporative Cooling Products
This equipment must only be installed, commissioned, serviced and repaired by suitably qualified and licensed personnel.
Before commencing work, complete a task-specific risk assessment and ensure safe roof access, fall protection requirements, electrical isolation procedures, service clearances and appropriate PPE have been considered. All work must comply with applicable regulations, standards and manufacturer requirements.
Particular care must be taken when working at heights, in roof spaces, ceiling spaces and other restricted access areas. Additional consideration must be given to confined working conditions, electrical hazards, moving parts, water systems, wet surfaces, manual handling risks and weather conditions.
Do not proceed if safe access, weather conditions, required clearances, confined space risks or appropriate safety controls cannot be achieved and maintained.
Safety takes priority over diagnosis, repairs, installation schedules and customer expectations. If the task cannot be completed safely, it must not proceed until the risks have been adequately controlled.
The wiring diagrams listed below are intended as a guide only for suitably licensed electrical workers. Seeley International is committed to continuous improvement, and as such, specifications are subject to change without notice.
Important:
It is the responsibility of the on-site electrician to ensure the wiring diagram is applicable and suitable for the specific product they are working on. Always verify the wiring diagram against the actual unit to confirm its accuracy.
Note: Carefully read the notes in the title of the wiring diagram to assist in determining its suitability.
RPA OR Wiring diagrams - AM014-E and RPB Wiring diagrams AM013-D
Historic Wiring Diagrams
The wiring diagrams listed below are intended as a guide only for suitably licensed electrical workers. Seeley International is committed to continuous improvement, and as such, specifications are subject to change without notice.
Important:
It is the responsibility of the on-site electrician to ensure the wiring diagram is applicable and suitable for the specific product they are working on. Always verify the wiring diagram against the actual unit to confirm its accuracy.
Note: Carefully read the notes in the title of the wiring diagram to assist in determining its suitability.
