077444 Auto Drain Kit (Obsolete) – Replacement Information and Legacy Installation Instructions
⚠️ Safety Notice – Commercial Evaporative Cooling Products
This equipment must only be installed, commissioned, serviced and repaired by suitably qualified and licensed personnel.
Before commencing work, complete a task-specific risk assessment and ensure safe roof access, fall protection requirements, electrical isolation procedures, service clearances and appropriate PPE have been considered. All work must comply with applicable regulations, standards and manufacturer requirements.
Particular care must be taken when working at heights, in roof spaces, ceiling spaces and other restricted access areas. Additional consideration must be given to confined working conditions, electrical hazards, moving parts, water systems, wet surfaces, manual handling risks and weather conditions.
Do not proceed if safe access, weather conditions, required clearances, confined space risks or appropriate safety controls cannot be achieved and maintained.
Safety takes priority over diagnosis, repairs, installation schedules and customer expectations. If the task cannot be completed safely, it must not proceed until the risks have been adequately controlled.
Overview
The 077444 Auto Drain Kit sold through Commercial Sales is obsolete and is no longer available.
This kit was previously used on selected Braemar commercial evaporative coolers, including legacy RPA, RPB, AL and RPC models. Installation information for these products has been retained in the attached reference document.
Auto Drain Kit 098809 is the current auto drain kit available for applicable Braemar commercial coolers. Due to differences in design and installation methods, it is not a direct replacement for legacy applications.
Spare parts used within the 077444 Auto Drain Kit remain available to support existing equipment in the field, subject to normal parts availability.
Always confirm cooler model compatibility before recommending or supplying a replacement auto drain kit.
Applicable Legacy Models
The obsolete 077444 Auto Drain Kit was used on selected Braemar commercial evaporative cooler models, including:
- RPA
- RPB
- AL
- RPC
Refer to the attached installation instructions for model-specific installation information.
Replacement Kit Information
098809 Auto Drain Kit is the current auto drain kit available for applicable Braemar commercial coolers.
Before supplying or installing a replacement kit:
- Confirm the cooler model.
- Confirm the cooler manufacturing period.
- Confirm compatibility with the replacement kit.
The installation method and component layout differ from the legacy 077444 kit.
Legacy Documentation
The final revision of the 077444 installation instructions has been retained for service and maintenance reference.
Attached Document
077444 Auto Drain Kit – Legacy RPA/RPB/AL/RPC Installation Instructions (638836 Rev J)
This document applies to legacy Braemar commercial coolers fitted with Auto Drain Kit 077444 and is provided for historical servicing and reference purposes only.
Frequently Asked Questions
Is Auto Drain Kit 077444 still available?
No. Auto Drain Kit 077444 is obsolete and is no longer available.
What replaces Auto Drain Kit 077444?
098809 is the current auto drain kit available for applicable Braemar commercial coolers.
Can Auto Drain Kit 098809 be fitted to any cooler that previously used 077444?
Not necessarily. Compatibility must be confirmed before recommending or supplying a replacement kit, as installation methods and cooler configurations vary between product generations.
Where can I find the old installation instructions?
Refer to the attached document:
077444 Auto Drain Kit – Legacy RPA/RPB/AL/RPC Installation Instructions (638836 Rev J)
Where can I find the current 098809 Auto Drain Kit installation instructions?
Refer to the link below
098809 RP Water Manager Kit Installation (RPS/RPM/RPL/RPXL) - 859758-A: Seeley International Pty Ltd